404 Not Found

Görüntülemeye çalıştığınız sayfa bulunamadı. Bu sayfa ya yayından kaldırılmış ya da hiç yayınlanmamış :)
Lütfen geldiğiniz yeri kontrol ediniz ya da aşağıdan arama yaparak istediğiniz sayfaya gidiniz.

Networking a HDVR2
Results 1 to 1 of 1

Thread: Networking a HDVR2

  1. #1
    Join Date
    Aug 2011
    Posts
    1

    Networking a HDVR2

    I have a HDVR2 hacked with ptvupgrade and etc.
    I have a Belkin usb ethernet adapter connected to the HDVR2 which is hard-wired to a hub/switch. All the computers connected to this hub/switch are hard-wired to a second ethernet card on each machine. Another words my Tivo network is separate from my WAN connection which is another separate network. Tivo setup as:

    STATIC_IP=192.168.1.98
    NETMASK=255.255.255.0
    BROADCAST=192.168.1.255
    GATEWAY=192.168.1.1

    All that said, I want to hard-wire a Belkin wireless router to the Tivo network so I can access the Tivo via my comps which are wireless, to use TivoWebPlus etc. Is this possible? And How would I set up the router to do so? I would prefer to keep the Tivo IP static if possible. What should the Local IP Address,Subnet Mask,Gateway be on the router?

    TIVO eth0
    eth0 Link encap:Ethernet HWaddr 00:05:1B:00:4F:58
    inet addr:192.168.1.98 Bcast:192.168.1.255 Mask:255.255.255.0
    UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
    RX packets:760657 errors:0 dropped:0 overruns:0 frame:0
    TX packets:0 errors:2147483647 dropped:1530314 overruns:0 carrier:0 coll:0

    TIA,
    Zundap

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •